high end low end - diy notes 
Tuesday, July 21, 2009, 11:04
If you would like to build the subs shown below in the "hig end low end" entry then these simulations and drawings will be of help.

Using the hornresp analysis and simulation software provided for free by David J McBean i finaly arrived at a good enough result, shown below.

Some of it's in swedish, but the graphs and dimensions (mm) are of course international.

this is the link to download hornresp:

These sumilations are based on some very basic 2D AutoCad drawings, shown here :

Just print them out and get to it, or simply hand them over to your local expert along with the money, either way i think you will be happily supprised at the result once loaded with the correct drivers, i certainly was :)

Comments are not available for this entry.